TESCOM減壓閥 調節器44-2263應該如何調節
詳細介紹
TESCOM減壓閥 調節器44-2263應該如何調節
減壓閥調大小有以下幾步：
第步：關閉減壓閥前的閘閥，開啟減壓閥后的閘閥，制造下游低壓環境；
第二步：將調節螺釘逆時針旋轉至最上位置（相對最低出口壓力），然后關閉減壓閥后閘閥；
第三步：慢慢開啟減壓閥前的閘閥至全開；
第四步：順時針慢慢旋轉調節螺釘，將出口壓力調至所需要的壓力（以閥后表壓為準）；
第五步：調整好后，將螺母鎖緊，打開減壓閥后閘閥；
注意：由于減壓閥的工作原理設定，因此如在調整時出口壓力高于設定壓力，須從開始重新調整，即只能從低壓向高壓調。
How to adjust the TESCOM pressure reducing valve regulator 44-
2263
How to adjust the TESCOM pressure reducing valve regulator 44-
2263
There are several steps to adjust the size of the pressure reducing
valve:
Step: Close the gate valve in front of the pressure reducing valve,
open the gate valve behind the pressure reducing valve, and create
a downstream low-pressure environment;
Step 2: Turn the adjustment screw counterclockwise to the highest
position (relative to the lowest outlet pressure), and then close the
yunlian technology inquiry and quotation njxj888@163.com
云聯電氣 技術支持 報價njxj888@163.com
